86 10 ... Removing rear supports and bracket

Release screws (1) and remove rear support (2) from bracket (3).

Installation: 

For tightening torque refer to 86 10 26AZ in 86 10 PLATFORM .

Fig 1: Rear Support, Screws And Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Remove cable holders (1) from bracket (2). Release screws (3) on left and right sides of bracket (2). Drill out rivets (4) from underside of platform. Drill out rivets (5) from upper side of platform.

Installation: 

For tightening torque refer to 86 10 27AZ in 86 10 PLATFORM .

Fig 2: Cable Holders, Bracket, Screws And Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Feed cable for rear light (1) through opening (2). Fit cable holders (4) in holes (3).

Fig 3: Rear Light Cable, Cable Holder, Opening And Holes

Courtesy of BMW OF NORTH AMERICA, INC.