41 00... Straightening Aluminum Components In Structure
- Reshaping or heating extruded sections and cast parts is not permitted!
- Reshaping of extruded sections and cast parts may only be used to achieve optimum joining of connecting faces (e.g. when bulkhead is damaged). Reshaped parts must be replaced.
- Repairs which affect the mounting points of mechanical assemblies and chassis components must be carried out on the straightening bench. Use the vehicle-specific straightening attachment set or vehicle-specific data sheet.
- Check windshield and rear window apertures for curvature by inserting the original glass.
- Take the gap dimensions for doors, engine hood and rear lid from the vehicle-specific gap dimension diagram.
- Exceptions on the E60, E61, E63, E64:
Carrier support and bulkhead may be straightened if they do not have any cracks, sharp-edged damage or holes. After repair work, check parts again for cracks.
Examine adjoining adhesive flanges for peeling off. If necessary, seal and preserve with SEALING COMPOUND .
Observe the frame alignment control dimensions for the carrier support.
Any repairs to the bulkhead if cracked outside the approved repair scopes are only permitted after consultation with and approval by BMW. Should you have any questions, please contact the country-specific Hotline.
Failure to comply with this requirement would have the following results:
In the case of reshaping, weld seams (E52) or glued connections (E60, E61, E63, E64) tear in the surrounding area.
In the case of reshaping, the material loses up to 40 % of its original strength.
In the case of heating, the material loses up to 40 % of its original strength.
The adhesive is destroyed at temperatures =120 °C (E60, E61, E63, E64).
Extruded sections and cast parts which show visible or measurable signs of deformation must be replaced.
Perform the check for deformation with the aid of the straightening system.
For optical testing, strip adjoining components in cases of doubt.
Extruded sections are used in the E52 as engine supports, door pillars, side members, etc.
Extruded sections are used in the E60, E61, E63, E64 as engine supports.
Cast parts are used in the E60, E61, E63, E64, E70, E71 as spring supports.
Straightening attachment supports and data sheets are also available for the top section, e.g.: door pillars, convertible top mounts, cowl, rear lid hinges, etc.