Check Control Message "Fuel Tank System Faulty" Is Displayed (51 17 15)
Publication date: 2015-09-01Reference number: 51 17 15
CHECK CONTROL MESSAGE "FUEL TANK SYSTEM FAULTY" IS DISPLAYED
TECHNICAL SERVICE BULLETIN
| BMW: | I12 (i8); Produced up to February 1, 2015 |
| GROUP: | Body Equipment |
SUBJECT
Check Control Message "Fuel tank system faulty" is displayed
SITUATION
The Check Control Message "Fuel tank system faulty" is displayed in the instrument cluster.
One or more of the following fault codes are stored:
- "806010 - Refueling button: button jammed open"
- "21B022 - Information for refueling button, function: jammed open (reported by TFE)"
CAUSE
The locking rod for the locking fuel filler flap is disconnected from the central locking system.
PROCEDURE
- Perform diagnosis using ISTA and identify if one or more of the fault codes listed above are stored. Work through the test modules to eliminate any wiring or connection issues.
- Replace the cover housing for the fuel filler. Refer to ISTA Repair Instructions "41 63 005 Remove and install cover pot for fuel filler neck".
Always connect a BMW approved battery charger / power supply (SI B 04 23 10 ) .
PARTS INFORMATION
| Part Number | Description | Quantity |
|---|---|---|
| 51 17 7 316 835 | Cover pot | 1 |
WARRANTY INFORMATION
Covered under the terms of the BMW New Vehicle Limited Warranty for Passenger Cars and Light Trucks
| Defect Code: | 41 63 00 41 00 |
| Labor Operation: | Labor Allowance: | Description: |
|---|---|---|
| 00 00 006 | Refer to KSD | Performing "vehicle test" (with vehicle diagnosis system - checking faults) |
| And: | ||
| 61 25 910 | Refer to KSD2 | Recharging high-voltage battery unit (to high voltage charging unit) |
| And, as necessary | ||
| 61 00 006 | Work time (WT) | Performing vehicle diagnosis - test module |
| And: | ||
| 41 63 601 | Refer to KSD2 | Remove and install fuel filler neck cover |
If you are using a Main labor code for another repair, use the Plus code labor operation 00 00 556 instead.
Refer to KSD2 for the corresponding flat rate unit (FRU) allowances.
Work time labor operation code 61 00 006 is not considered a Main labor operation; however, it does require an individual punch time and an explanation on the repair order and in the claim comments.
Other Repairs
If other eligible and covered work is performed as a result of performing the ISTA diagnostics and related test plans results, claim this work with the applicable defect code and labor operations listed in KSD2.