Front Brake, BMW, I01

IMPORTANT: Installation of new brake pads is approved only provided that the brake disc thickness exceeds the specified dimension for "MIN TH" (see table). Brake discs must be replaced when they reach the nominal thickness (see table) minus 2.4 mm!(Not applicable to perforated brake discs and M vehicles).Depending on: Engine type Transmission version Equipment specification (e.g. maximum load increase, chassis official-use, national version, etc.) different brake discs can be fittedThe brake discs must always be identified by the relevant vehicle identification number and the applicable BMW parts catalogue!
Different thicknesses on brake linings	Max. mm	0.01
Nominal size (diameter x thickness)	mm	280x20
(MIN TH) is stamped in brake disc chamber	mm	18.4
Pad wear warning from remaining brake pad thickness	mm	3.7