Axle guide and axial struts
31 12 AXLE GUIDE AND AXIAL STRUTS - TIGHTENING TORQUES SPECIFICATIONS
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Wishbone to front axle support | I01 | M12 | Replace screw and nut. Tighten in NORMAL POSITION . |
|
| Joining torque | 100 Nm | |||
| Angle of rotation | 90° | |||
| 2AZ Wishbone to swivel bearing | I01 | M16 | Replace nut. | |
| Joining torque | 100 Nm | |||
| Angle of rotation | 90° | |||
33 32 AXLE GUIDE AND AXIAL STRUTS - TIGHTENING TORQUES SPECIFICATIONS
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Trailing arm to rear axle support | I01 | M12 | Up to 02/2014: Replace screw and nut. From 02/2014: Replace screw. Tighten in NORMAL POSITION . |
|
| Joining torque | 100 Nm | |||
| Angle of rotation | 90° | |||
| 2AZ Trailing arm to wheel carrier | I01 | M12 | Up to 02/2014: Replace screw and nut. From 02/2014: Replace screw. Tighten in NORMAL POSITION . |
|
| Joining torque | 100 Nm | |||
| Angle of rotation | 90° | |||
| 3AZ Control arm on rear axle module | I01 | M12 | Replace screw and nut. Tighten down in NORMAL POSITION . |
|
| Joining torque | 100 Nm | |||
| Angle of rotation | 90° | |||
| 4AZ Control arm to wheel carrier | I01 | M12 | Replace screw and nut. Tighten in NORMAL POSITION . |
|
| Joining torque | 100 Nm | |||
| Angle of rotation | 90° | |||
| 5AZ Wishbone on rear axle module | I01 | M12 | Up to 02/2014: Replace screw and nut. From 02/2014: Replace screw. Tighten in NORMAL POSITION . |
|
| Joining torque | 100 Nm | |||
| Angle of rotation | 90° | |||
| 6AZ Wishbone to wheel carrier | I01 | M12 | Up to 02/2014: Replace screw and nut. From 02/2014: Replace screw. Tighten in NORMAL POSITION . |
|
| Joining torque | 100 Nm | |||
| Angle of rotation | 90° | |||
| 7AZ Control link on rear axle module | I01 | M14 | Replace screw, eccentric washer and nut. Tighten in NORMAL POSITION . |
165 Nm |
| 8AZ Track arm to wheel carrier | I01 | M12 | Replace screw. Tighten in NORMAL POSITION . |
|
| Joining torque | 100 Nm | |||
| Angle of rotation | 90° | |||
| 9AZ Camber control arm on rear axle module | I01 | M14 | Replace screw, eccentric washer and nut. Tighten in NORMAL POSITION . |
165 Nm |
| 10AZ Camber control arm to wheel carrier | I01 | M12 | Replace screw and nut. Tighten in NORMAL POSITION . |
|
| Joining torque | 100 Nm | |||
| Angle of rotation | 90° | |||