Removing all cell blocks

NOTE: The description is provided only at one component. The procedure is the same for all other components.

Remove cell module

Disconnect high-voltage connector (1).
Disconnect connector (2) at communication wiring harness.
Unclip the communication cable wiring harness in the area of the cell block.
After disconnecting high-voltage connector (1), perform a visual inspection!
Technical support must be contacted if high-voltage connectors are damaged!

Courtesy of BMW OF NORTH AMERICA, INC.
Undo screws (1) and remove module struts (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Undo nuts (1) at cell module (2) using special tool 2 357 541 .

Courtesy of BMW OF NORTH AMERICA, INC.
Lift out cell module (1) vertically using special tool 2 356 858 and with help of a second person.

Courtesy of BMW OF NORTH AMERICA, INC.