Programming the Receiver

In Trunk Programming Receiver Connector-Sedan (Used Fused Jumper):

Programming Receiver Connector - Wagon (ground B To 8):

Programming The Receiver
^ Move rear compartment carpeting out of the access the programming connector.

^ Jumper the two connector terminals together.

^ The door lock and rear compartment lid solenoids will cycle indicating the receiver is in program mode.

^ Depress any button (only once) on the transmitter.

^ The door lock and rear compartment lid solenoids will cycle once confirming the transmitter code is programmed.

^ Any transmitter code that was previously programmed has been erased.

^ If programming a second transmitter, depres� button (only once) on the transmitter.

^ The door lock and rear compartment lid solenoids will cycle once confirming that transmitter code is programmed.

^ Remove the jumper.

^ The system will not operate if the jumper is not removed.

^ Verify operation of transmitter.

^ Replace rear compartment carpeting.