Specifications Index
PARK AVENUE SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | A/C SYSTEM SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | 107 ft. lbs. (145 N.m) | ||
| Battery | BATTERY SPECIFICATIONS | ||
| Brakes | |||
| Bleeding Sequence | Right Rear, Left Rear, Right Front, Then Left Front, See MANUAL BLEEDING PROCEDURE | ||
| Disc Brakes | |||
| Service Specifications | DISC BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | CS130D - 105 Amp | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Drive Belt Routing | See appropriate illustration under SERPENTINE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | NA | ||
| Radiator Cap Pressure | Specification is stamped on pressure cap | ||
| Thermostat R & I | |||
| 3.8L | THERMOSTAT | ||
| Water Pump R & I | |||
| 3.8L | WATER PUMP | ||
| Engine Mechanical | |||
| 3.8L | |||
| Compression | lowest reading should not be less than 70% of highest reading No cylinder reading should be less than 689 kPa (100 psi) |
||
| Oil Pressure (At Operating Temperature 1850 RPM Using 10W-30 Oil ) | 60 psi (414 kPa minimum | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | 11 ft. lbs. (15 N.m) Additional 50 Degrees |
||
| Fuel System | |||
| Pressure Specification | 48-55 psi (333-376 kPa) | ||
| Fuel Pressure Test Procedure | FUEL DELIVERY | ||
| Fuel Filter Location | In-Line Fuel Filter Is Mounted On The Right Side Of The Underbody | ||
| Fuel Filter R & I | IN-LINE FUEL FILTER | ||
| Ignition | |||
| Firing Order & Cylinder Identification | |||
| 3.8L | FIRING ORDER/CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | |||
| Wire And Coil Routing | See Illustration Under FIRING ORDER/CYLINDER IDENTIFICATION | ||
| Spark Plug | |||
| VIN K AC 41-921 VIN 1 AC 41-601 |
|||
| Gap | .060 in. (1.52 mm) | ||
| Torque | 11 ft. lbs. (15 N.m) | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 100 ft. lbs. (136 N.m) | ||