LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2000 >> Century Custom >> Repair and Diagnosis >> External Pages >> Different car >> Section 307 (Engine Exhaust System) >> Repair Instructions >> Engine Mount Heat Shield Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Firebird and 2002 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine mount heat shield.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the engine mount heat shield nuts.
    Fig 1: Installing Engine Mount Heat Shield Nuts
    G01731972Courtesy of GENERAL MOTORS CORP.

    Tighten 

    Tighten the engine mount heat shield nuts to 10 N.m (89 Inch lbs).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals