Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Ignition Coil Module And Module Mounting Bracket

Courtesy of GENERAL MOTORS CORP.

Attach the coils (2) and the ignition control module (3) to the bracket.
Install the screws (1) that retain the ignition coils (2) and the ICM (3) to the bracket.
Tighten: Tighten the screws to 4.5 N.m (40 lb in).
Connect the spark plug wires.
Connect the 14-way connector to the module.
Tighten: Tighten the screw to 2.1 N.m (19 lb in).