Pass-Key(R) III System Quick Learn Procedure
NOTE:
PASS-Key(R) III system quick learn procedure is used to learn additional ignition keys (Black master or Gray valet). A learned Black master key must be used to initiate procedure. Up to 10 ignition keys can be learned.
- Insert a valid master ignition key in the ignition switch. Start engine. After 10 seconds, turn ignition off and remove key.
- Within 10 seconds, insert new valid mechanical code unlearned key and turn ignition switch to RUN position. SECURITY indicator light will illuminate until key is learned. This may happen so quickly light illumination is not observed. Turn ignition off. Remove ignition key 10 seconds after light goes out. To learn additional keys, repeat this step.