Specifications Index
PARK AVENUE SPECIFICATIONS INDEX
| System | Specification/Procedure | |
|---|---|---|
| Air Conditioning | ||
| Service | SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Axle Nut/Hub Nut | ||
| Front | 118 Ft. Lbs. (160 N.m) | |
| Battery | BATTERY TESTING & INSPECTION | |
| Brakes | ||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | |
| Disc Brakes | DISC BRAKE SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Charging | ||
| Generator | GENERATOR SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Drive Belts | ||
| Adjustment | BELT ADJUSTMENT | |
| Belt Routing | See appropriate illustration under SERPENTINE BELT ROUTING & ALIGNMENT | |
| Engine Cooling | ||
| Service | COOLING SYSTEM SPECIFICATIONS | |
| Radiator Cap Pressure | 15 psi (or pressure listed on cap) | |
| Thermostat R&I | THERMOSTAT REPLACEMENT | |
| Water Pump R&I | WATER PUMP | |
| Engine Mechanical | ||
| Compression | Lowest compression reading should not be less than 70 percent of highest compression reading. No cylinder compression reading should be less than 100 psi (7.0 kg/cm2 ). | |
| Oil Pressure | With engine at normal operating temperature, oil pressure (with 5W-30 or 10W-30 engine oil) should be 60 psi (4.2 kg/cm2 ) at 1850 RPM. | |
| Overhaul | ENGINE SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |
| Flywheel/Flex Plate Torque | ||
| Step 1 | 11 (15) | |
| Step 2 | Additional 50 Degrees | |
| Fuel System | ||
| Pressure Specification (Key On Engine Off) | VIN 1 48-55 psi (3.4-3.9 kg/cm2
) VIN K 52-59 psi (3.7-4.2 kg/cm2 ) |
|
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE TEST (EXCEPT AURORA & SATURN) | |
| Ignition | ||
| Firing Order & Cylinder Identification | See FIRING ORDER & CYLINDER IDENTIFICATION | |
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | |
| Ignition Wires/Coils (Routing) | See appropriate illustration under FIRING ORDER | |
| Spark Plug | ||
| Type | AC 41-921 | |
| Gap | .060 in. (1.52 mm) | |
| Torque | 11 Ft. Lbs. (15 N.m) | |
| Starting | ||
| Starter | SYSTEM TESTS | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel Alignment | ||
| Adjustment | WHEEL ALIGNMENT SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel & Tire | ||
| Wheel Lug Nut Torque | 100 Ft. Lbs. (136 N.m) | |