LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2003 >> LeSabre Custom, 4T65E/MN3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 1285 (Body Control System) >> Repair Instructions >> Instrument Panel Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Instrument Panel Module Fasteners and Electrical Connectors
    GM428511Courtesy of GENERAL MOTORS CORP.
  1. Install the instrument panel module (IPM) (1) to the vehicle.
  2. Connect the electrical connectors to the IPM (1).
  3. Install the IPM (1) to the IP retainer by inserting the top tab of the module into the slot on the IP retainer and rotating down.
  4. Install the fastener.

    Tighten:  Tighten fastener to 2 N.m (18 lb in).

  5. Install the left closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
  6. Program the instrument panel module. Refer to Body Control Module (BCM) Programming/RPO Configuration (IPM) , Body Control Module (BCM) Programming/RPO Configuration (DIM)  or Body Control Module (BCM) Programming/RPO Configuration (RIM) .
scientia non olet · About LEMON Manuals