LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2004 >> Century Base >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pulley Replacement (3.1L) >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: Removing/Installing The Power Steering Pump Pulley From The Power Steering Pump
    GM293353Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Never use a hammer to install the power steering pulley.
    • The face of the power steering pulley hub must be flush with the end of the power steering pump driveshaft.
  1. Using J 25033-C  install the power steering pump pulley to the power steering pump.
  2. Install the accessory drive belt. Refer to Drive Belt Replacement in Engine Mechanical-3.1L.
  3. Fill the power steering system. Refer to Checking and Adding Power Steering Fluid .
  4. Bleed the power steering system. Refer to Bleeding the Power Steering System .
  5. Inspect the power steering system for leaks. Refer to Power Steering Fluid Leaks .
scientia non olet · About LEMON Manuals