LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2004 >> Century Base >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pulley Replacement (W/3.8L) >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    IMPORTANT:
    • Never use a hammer to install the power steering pulley.
    • The face of the power steering pulley hub must be flush with the end of the power steering pump driveshaft.
    Fig 1: Removing/Installing The Power Steering Pump Pulley From The Power Steering Pump
    GM293353Courtesy of GENERAL MOTORS CORP.
  1. Using J 25033-C  install the power steering pump pulley to the power steering pump.
  2. Install the power steering pump to the engine. Refer to Power Steering Pump Replacement (3.1L)  or Power Steering Pump Replacement (3.8L) .
  3. Fill the power steering system. Refer to Checking and Adding Power Steering Fluid .
  4. Bleed the power steering system. Refer to Bleeding the Power Steering System .
  5. Inspect the power steering system for leaks. Refer to Power Steering Fluid Leaks .
scientia non olet · About LEMON Manuals