LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2006 >> Lucerne CXS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 4.6L - DTC P0016 To DTC P0401 >> DTC P0102 or P0103 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the MAF/IAT sensor.
  2. Ignition OFF, allow at least 60 seconds for the control module to power down.
  3. Test for less than 5 ohms of resistance between the ground circuit terminal C and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  4. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal B and ground.
    • If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
  5. Ignition ON, test for 4.8-5.2 volts between the signal circuit terminal A and ground.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  6. Connect the J 38522  to the vehicle. Refer to Component Testing  for instructions.
scientia non olet · About LEMON Manuals