LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2007 >> Allure CXS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.6L - DTC P0135 To P0420 >> DTC P0324 >> Test Description
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  This step determines if a condition exists.
  2. 3:  A crankshaft sensor DTC could cause this DTC to set.
DTC P0324

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2 
IMPORTANT: If you can hear an engine knock, repair the engine mechanical condition before proceeding with this diagnostic. Refer to Symptoms - Engine Mechanical .
  1. Observe the Freeze Frame/Failure Records for this DTC.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure records.
Did the DTC fail this ignition?		 Go to Step 3  Go to Intermittent Conditions
3  Is DTC P0335, P0336, or P0338 also set? Go to Diagnostic Trouble Code (DTC) List - Vehicle Go to Step 4 
4 Replace the engine control module (ECM). Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 5  -
5
  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?		 Go to Step 2  Go to Step 6 
6 Observe the Capture Info with a scan tool.
Are there any DTCs that have not been diagnosed?		 Go to Diagnostic Trouble Code (DTC) List - Vehicle System OK
scientia non olet · About LEMON Manuals