LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Buick >> 2009 >> Allure Super >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 5.3L - DTC P0016 To DTC P0358 >> DTC P0112 or P0113 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

IMPORTANT: All electrical components and accessories must be turned OFF and allowed to power down.
  1. Ignition OFF, disconnect the MAF/IAT harness connector at the MAF/IAT sensor.
  2. Ignition OFF, test for less than 5 ohms of resistance between the low reference circuit terminal E and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, verify the scan tool IAT Sensor parameter is less than -39°C (-38°F).
    • If greater than the specified range, test the signal circuit for a short to ground. If the circuit tests normal, replace the ECM.
  4. Install a 3A fused jumper wire between the signal circuit terminal D and a good ground. Verify the scan tool IAT Sensor parameter is greater than 149°C (300°F).
    • If less than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  5. If all circuits test normal, test or replace the MAF/IAT sensor.
scientia non olet · About LEMON Manuals