Circuit/System Testing
NOTE:
It is recommended that Component Testing is performed before Circuit/System Testing when diagnosing the variable power steering solenoid valve.
- Ignition OFF, disconnect the harness connector at the M72 Variable Power Steering Solenoid Valve.
- Ignition ON, test for less than 0.3 V between the control terminals listed below and ground.
- M72 Variable Power Steering Solenoid Valve, terminal A
- M72 Variable Power Steering Solenoid Valve, terminal B
- If greater than the specified value, test the control circuits for a short to voltage. If the circuits test normal, replace the K43 Power Steering Control Module.
- Ignition OFF, disconnect harness connector at the K43 Power Steering Control Module.
- Test for infinite resistance between the circuit terminal listed below and ground:
- M72 Variable Power Steering Solenoid Valve connector terminal 1
- M72 Variable Power Steering Solenoid Valve connector terminal 2
- If less than the specified value, test the control circuit for a short to ground.
- Test for less than 2 Ω between the control circuit terminals listed below:
- M72 Variable Power Steering Solenoid Valve, terminal 1 and K43 Power Steering Control Module, terminal 2
- M72 Variable Power Steering Solenoid Valve, terminal 2 and K43 Power Steering Control Module, terminal 3
- If greater than the specified value, test the control circuit for an open/high resistance.
- If all circuits test normal, test or replace the M72 Variable Power Steering Solenoid Valve.
- Clear the DTCs and operate the vehicle within the conditions for running the DTC. Verify DTC C0450 does not set.
- If the DTC sets, replace the K43 Power Steering Control Module.