Steering Linkage Outer Tie Rod Replacement

Callout	Component Name
Preliminary Procedure Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
1	Steering Linkage Tie Rod Nut WARNING: Refer to Torque-to-Yield Fastener Warning . CAUTION: Refer to Fastener Caution . Procedure Install NEW steering linkage tie rod nut. DO NOT re-use the old nut. Tighten Tighten the nut a first pass to 35 N.m (26 lb ft) Tighten the nut a final pass to an additional 30 to 45 degrees, using the EN-45059 meter. Special Tools EN-45059 Angle Meter For equivalent regional tools, refer to Special Tools .
2	Steering Linkage Inner Tie Rod Nut Tighten 60 N.m (44 lb ft)
3	Steering Linkage Outer Tie Rod Procedure Use CH-161-B puller to separate the steering linkage outer tie rod from the steering knuckle. Inspect the steering linkage inner tie rod for bent or damaged threads. Clean the tapered surface of the steering knuckle. Check and adjust wheel alignment. Refer to Wheel Alignment Measurement . Center the steering angle sensor. Refer to Steering Wheel Angle Sensor Centering . Special Tools CH-161-B Puller For equivalent regional tools, refer to Special Tools .