Diagnostic Aids
- If the driver does not fully depress the brake pedal, the vehicle may not enter Auto Stop mode.
- Auto Stop may be deactivated if any of the following conditions are present:
- Ambient and coolant temperature correlation does not match specified values
- Ambient temperature is less than -10°C (14°F)
- Battery temperature is less than 0°C (32°F) or greater than 55°C (131°F)
- HVAC system demand is high
- HVAC defrost has been selected
- Battery charge is low
- The battery was improperly charged or jump started.
To properly charge the battery or jump start the vehicle, the negative lead of the charger must be connected to chassis ground, NOT directly to the negative battery post. Connecting to chassis ground allows current to flow through the battery sensor module during charging and be measured. Connecting directly to the negative battery post charges the battery, but the current is not measured by the battery sensor module.
- Power on Reset is active when the parameters Battery Sensor Module Battery State Information and Battery Sensor Module Reset Occurred - Using Estimated State of Charge read Not Available (Not Learned) and Yes (Estimated). Stop/start is enabled when Power on Reset is active.
- Vehicle has not been allowed to sit for at least 3 hours over 1 week.
- Parasitic current draw 100 mA or greater.
- When using a vehicle hoist to verify autostop and autostart operation, ensure the following conditions are also met:
- Transmission gear selector is in the drive position
- No DTCs are set
- Traction control is off