Removal Procedure

WARNING: This page is about a different car, the 2017 GMC Acadia Limited, 2017 Chevrolet Traverse, and 2017 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Lifting and Jacking the Vehicle
Remove the front tire and wheel assembly. Tire and Wheel Removal and Installation
Separate Steering Linkage Outer Tie Rod at Steering Knuckle - Steering Linkage Outer Tie Rod Replacement
Loosen the front lower control arm ball stud nut.

Fig 1: Special Tool Ball Joint Separator

Courtesy of GENERAL MOTORS COMPANY

Use the CH-42188 - B separator (1) to separate the front lower control arm from the steering knuckle.

Fig 2: Lower Ball Joint Retaining Nut

Courtesy of GENERAL MOTORS COMPANY

Remove the front lower control arm ball stud nut (1).

Fig 3: Control Arm Mounting Bolt And Nut

Courtesy of GENERAL MOTORS COMPANY

Remove the front lower control arm front nut (4) from the front lower control arm front stud (3).
Remove the front lower control arm rear nut (2) and front lower control arm rear bolt (1).

Fig 4: Lower Control Arm

Courtesy of GENERAL MOTORS COMPANY

Remove the front lower control arm (1) from the vehicle.