Installation Procedure
Install the exhaust front pipe (3) to the catalytic converter with a NEW gasket (1) and hand tighten the fasteners (2).
- CAUTION:
Refer to Flex Decoupler Caution .
CAUTION:Refer to Fastener Caution .
Install the exhaust front pipe (5) to the warm up 3 way catalytic converter (3) with a NEW gasket (2) and tighten the fasteners (4) to 17 N.m (13 lb ft).
Tighten the exhaust front pipe fasteners (2) to 22 N.m (16 lb ft).
- Connect the heated oxygen sensor - position 2 to the engine wiring harness.
- Start the engine and check for exhaust leaks.