Circuit/System Testing
- Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the K17 Electronic Brake Control Module, ignition ON.
- Test for less than 1 V between the K17 Electronic Brake Control Module harness connector terminals listed below and ground:
- B5LF Left Front Wheel Speed Sensor - terminal 7
- B5RF Right Front Wheel Speed Sensor - terminal 26
- B5LR Left Rear Wheel Speed Sensor - terminal 23
- B5RR Right Rear Wheel Speed Sensor - terminal 37
- If 1 V or greater
Repair the short to voltage on the circuit.
- Go to next step: If less than 1 V
- All OK.