Installation Procedure

WARNING: This page is about a different car, the 2018 Buick Envision. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Front Brake Caliper Bracket (1) - Install
Prepare the brake caliper bracket bolts and the bracket threaded holes for assembly:
- Thoroughly clean the residue from the bolt threads with denatured alcohol or equivalent and allow to dry.
- Thoroughly clean the residue from the threaded holes with denatured alcohol or equivalent and allow to dry.
- Apply threadlocker to 2/3 of the threaded length of the bolts. Adhesives, Fluids, Lubricants, and Sealers
- Ensure there are no gaps in the threadlocker along the length of the filled area of the bolts.
- Allow the threadlocker to cure approximately 10 minutes before installation.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Brake Caliper Bracket Bolt (1) - Install [2x] 150 N.m (111 lb ft) + 15-30 degrees
Courtesy of GENERAL MOTORS COMPANY

Caliper Upper Guide Pin (1) Guide Pin Seal (2) - Install
Courtesy of GENERAL MOTORS COMPANY

Caliper Lower Guide Pin (1) Guide Pin Seal (2) - Install
Courtesy of GENERAL MOTORS COMPANY

Disc Brake Pad Spring (1) - Install [2x]
Courtesy of GENERAL MOTORS COMPANY

Outer Disc Brake Pad (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Inner Disc Brake Pad (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Brake Caliper Guide Pin Bolt (1) - Install [2x] 47 N.m (35 lb ft)
Install the tire and wheel assembly. Tire and Wheel Removal and Installation