Installation Procedure
Install a NEW turbocharger clamp (1).
Install the catalytic converter into the catalytic converter brace (2) and loosely tighten the fasteners (1).
- CAUTION:
Refer to Fastener Caution .
Install the exhaust front pipe (3) to the catalytic converter with a NEW gasket (2) and tighten the fasteners (1) to 22 N.m (16 lb ft).
Tighten the catalytic converter brace fasteners (1) to 22 N.m (16 lb ft).
- Lower the vehicle.
- Tighten the turbocharger clamp fastener to 13 N.m (115 lb in).
- Install the exhaust manifold heat shield. Exhaust Manifold Heat Shield Replacement (LUV)
- Install the catalytic converter heated oxygen sensor - 1. Heated Oxygen Sensor Replacement - Sensor 1
- Start the engine and check for exhaust leaks.