Fastener Specifications
WARNING: This page is about a different car, the 2022 Buick Envision. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Differential Carrier Front Bolt | |
|
80 N.m (59 lb ft) |
|
60 - 75 degrees |
| Differential Carrier Rear Bolt | |
|
100 N.m (74 lb ft) |
|
30 - 45 degrees |
Reusable Threaded Fastener Tightening Specifications
| Application | Specification |
|---|---|
| Metric (English) | |
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
| Differential Clutch Cover Drain Plug | 25 N.m (18 lb ft) |
| Differential Clutch Cover Fill Plug | 25 N.m (18 lb ft) |
| Limited Slip Differential Clutch High Pressure Pipe | 24 N.m (18 lb ft) |
| Rear Axle Housing Drain Plug | 25 N.m (18 lb ft) |
| Rear Axle Housing Fill Plug | 25 N.m (18 lb ft) |
| Rear Differential Clutch Control Module Bolt | 6 N.m (53 lb in) |