Installation Procedure

Position a NEW steering gear boot inner clamp (1) on the steering gear boot (2).

Courtesy of GENERAL MOTORS COMPANY
Steering Gear Boot (1) - Install

Courtesy of GENERAL MOTORS COMPANY
Steering Gear Boot Inner Clamp (1) - Tighten- use DT-35910 Drive Axle Boot Clamp Pliers (2)

Courtesy of GENERAL MOTORS COMPANY
Steering Gear Boot Outer Clamp (1) - Install

Courtesy of GENERAL MOTORS COMPANY
Install the steering linkage inner tie rod nut (1) until aligned with the previously placed matched mark on the steering linkage inner tie rod.

Courtesy of GENERAL MOTORS COMPANY
Steering Linkage Outer Tie Rod - Install - Steering Linkage Outer Tie Rod Replacement
Warm Up Three-Way Catalytic Converter - Install - Warm Up Three-Way Catalytic Converter Replacement
Front Compartment Air Deflector (1) - Install - Front Compartment Air Deflector Replacement (Base) , or Front Compartment Air Deflector Replacement (Oil Filter Access)

Courtesy of GENERAL MOTORS COMPANY
Measure and adjust the front toe. Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment