Test C: Radio & Wipers Will Not Operate When Retained Accessory Power (Rap) Feature Is Activated

RAP RELAY 2

Condition

Connect Between

⁽¹⁾ Correct Result

RAP Relay 2 Disconnected: Connect Test Lamp At RAP Relay 2 Connector

⁽²⁾ 5 (RED/YEL) & Ground

⁽³⁾ Test Lamp Lights

RAP Relay 2 Disconnected: Connect Test Lamp At RAP Relay 2 Connector

⁽²⁾ 4 (RED) & Ground

⁽⁴⁾ Test Lamp Lights

⁽¹⁾	If results are correct, go to RAP RELAY 2 TABLE 2 .

⁽²⁾	For terminal identification, see CONNECTOR IDENTIFICATION .

⁽³⁾	If results are incorrect, check RED/YEL (840) wire for an open.

⁽⁴⁾	If results are incorrect, check RED (2) wire for an open.

RAP RELAY 2

Condition

Connect Between

Correct Result

⁽¹⁾ BCM Display

RAP Relay 2 Disconnected: Connect Test Lamp At RAP Relay 2 Connector; Select BCM Output Test BO03

⁽²⁾ 5 (RED/YEL) & 2 (BLK/WHT)

Test Lamp Lights

⁽³⁾ LO

RAP Relay 2 Disconnected: Connect Test Lamp At RAP Relay 2 Connector; Select BCM Output Test BO03

⁽²⁾ 5 (RED/YEL) & 2 (BLK/WHT)

Test Lamp Does Not Light

⁽³⁾ HI

⁽¹⁾	If the BCM display does not cycle from LO to HI, replace the BCM.

⁽²⁾	For terminal identification, see CONNECTOR IDENTIFICATION .

⁽³⁾	If test lamp lights as shown, go to RAP RELAY 2 TABLE 3 . If test lamp does not light as indicated, check BLK/WHT (707) wire for an open.

RAP RELAY 2

Condition

Connect Between

⁽¹⁾ Correct Result

For Diagnosis

RAP Relay 2 Disconnected: Ignition Off; Connect Fused Jumper At RAP Relay 2 Connector

⁽²⁾ 4 (RED) & 1 (BRN)

Radio & Wipers Operate

⁽³⁾

⁽¹⁾	If result is correct, replace RAP Relay 2.

⁽²⁾	For terminal identification, see CONNECTOR IDENTIFICATION .

⁽³⁾	If result is incorrect, check BRN (4) wire for an open.