LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 1992 >> Seville Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Controls - System/Component Tests) >> Engine Sensors & Switches >> Engine Controls - System/Component Tests >> Oxygen (O2) Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Oxygen (O2) Sensor

WARNING: This page is about a different car, the 1992 Oldsmobile Toronado, 1992 Cadillac Eldorado, and 1992 Buick Riviera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine and warm to operating temperature. Disconnect oxygen sensor. Connect a DVOM between lead of oxygen sensor and ground. Place meter on the 2-volt scale. Voltmeter reading should increase to greater than .8 volt.
  2. Using another DVOM on the 20-volt scale. Connect voltmeter in series between the O2 wire from the ECM and the positive post of battery. Reading on voltmeter connected to oxygen sensor should decrease to a low voltage (less than .3 volt).
  3. If a second DVOM is not available, install short jumper in O2 wire 6from the ECM. Hold jumper in one hand and touch positive post of battery with other hand. This should cause oxygen sensor to produce less than .3 volt. For additional testing procedures, see appropriate G - TESTS W/ CODES article in this section.
scientia non olet · About LEMON Manuals