LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 1993 >> Fleetwood Base >> Repair and Diagnosis (Single Page) >> Steering >> Power Steering >> Steering System - Variable Effort >> Testing >> VES Input Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

VES Input Test

  1. Turn ignition off. Disconnect VES control module connector. Turn ignition switch to RUN position. Measure voltage at Pink/White wire terminal of VES control module connector.
  2. If battery voltage is not present, check C/C fuse in engine compartment fuse block. If fuse is okay, repair open or short to ground in Pink/White wire between C/C fuse and VES control module.
  3. If battery voltage is present, turn ignition off. Measure resistance between ground and Black wire terminal of VES control module connector. If 5 or more ohms resistance is measured, repair open in Black wire between VES control module and ground.
  4. If less than 5 ohms resistance is measured, raise and support rear of vehicle with wheel off ground. Start engine. Place transmission in Drive. Measure voltage between Pink/White and Yellow/Black wire terminals of VES control module connector.
  5. If voltage varies between 7 and 12 volts, go to next step. If voltage does not vary between 7 and 12 volts, check for open or short to ground in Yellow/Black wire circuit between VES control module and VSS buffer. If circuit is okay, replace VSS buffer.
  6. Check for poor connection at VES control module connector. If connection is okay, replace VES control module.
scientia non olet · About LEMON Manuals