Pcm Code P058 - Pass-Key Fuel Enable Problem: Action

THEFT SYSTEM PROBLEM, CAR MAY NOT RESTART message is displayed on DIC. Enables fuel injection on future ignition cycles without regard for PASS-Key fuel enable input status.

1. If engine will crank, problem has been isolated to PASS-Key module, PCM or fuel enable circuit. If engine will not crank, perform PASS-Key system diagnosis. See PASS-KEY DIAGNOSIS.
2. Checking voltage to PCM will identify if PCM is at fault. Typical signal will be about 2.5 volts.
3. Voltage too low; problem could be a faulty PASS-Key module, poor connection at PCM or a short to ground in fuel enable circuit.
4. Voltage too high; problem could be a faulty PASS-Key module, poor connection at PASS-Key module, short to voltage or an open in fuel enable circuit.