Checking Fluid Level
CAUTION:
DO NOT
overfill transmission. When transmission is hot, one pint of fluid will raise fluid level from ADD 1 PT. OR .5L mark to FULL HOT mark on dipstick.
- Start engine, and operate vehicle for at least 15 minutes or until reaching operating temperature. With engine at curb idle and vehicle on level ground, move gear selector lever through all ranges ending in Park.
- Remove transmission dipstick, wipe clean and fully reinsert into filler tube. Remove dipstick again, and inspect fluid level. Fluid level should be between ADD 1 PT. OR .5L mark and FULL HOT mark on dipstick.
CAUTION:
If vehicle has been driven for an extended period of time at high speeds, in city traffic, in hot weather or if vehicle has been pulling a trailer, an accurate fluid level reading cannot be made until vehicle has been parked and ATF is allowed to cool about 30 minutes.