Code P014, Shorted ECT Sensor Signal: Action

PCM turns on MIL and uses IAT sensor value instead of coolant sensor value for all calculations during first 10 minutes of operation; PCM then uses a value of 194°F (90°C). Transaxle shift adapts are maintained at current levels.

NOTE: Test numbers refer to numbers on diagnostic chart.

With ECT sensor or wiring shorted, PCM parameter PD04 should indicate 298°F (148°C) or greater. If PD04 does not indicate 298°F (148°C) or greater, see NOTE ON INTERMITTENTS.
Checks for shorted sensor or circuit No. 410. If parameter value stays at 147°C or greater with sensor unplugged, short is in circuit No. 410 between terminal "B" and PCM terminal 3E16.
Check PCM connector. Fault is most likely at PCM connector or PCM.