LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 1995 >> Eldorado Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine Controls - Remove/Install/Overhaul) >> Ignition System >> Knock Sensor Module >> Removal & Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

WARNING: This page is about a different car, the 1995 Cadillac Seville and 1995 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Remove PCM from vehicle. See POWERTRAIN CONTROL MODULE (PCM) . Position PCM so access cover faces upward. Remove access cover from PCM.
  2. Using thumb and forefinger, squeeze both ends of knock sensor module inward and pull module up from access hole. To install, reverse removal procedure. Ensure module latches into holder in PCM.
scientia non olet · About LEMON Manuals