LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 1996 >> Seville STS >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System - Tests W/Codes >> Diagnostic Trouble Codes >> DTC P1377 - Ignition Control (Ic) Module Cam Pulse To 4X Reference Pulse Comparison >> Diagnostic Procedures
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedures

  1. Perform On-Board Diagnostic (OBD) System Check. After performing OBD system check, go to next step.
  2. If any other DTC(s) are present, diagnose affected DTC(s) first. If no other DTC(s) are present, go to next step.
  3. If this DTC is set along with a driveability complaint, go to next step. If DTC is not set along with a driveability complaint, fault is not present, see DIAGNOSTIC AIDS.
  4. This DTC will set when are too many or too few cam or 4X pulses. Check for Electromagnetic Interference (EMI) being induced in the fuel control circuit, cam signal circuit or camshaft position sensor circuits by improper spark plug wire routing or high power transmitter operating in the vicinity. Correct any causes of EMI. If EMI is not present, go to next step.
  5. Check for intermittent short to ground, circuit shorted together or open in fuel control circuit, cam signal circuit or camshaft position sensor circuits. Repair as necessary. If circuits are okay, go to next step.
  6. Check terminal contacts at camshaft position sensor terminals. Repair as necessary. If terminal contacts are okay, go to next step.
  7. Check terminal contact at camshaft position sensor to IC module. Check terminal contact at fuel control circuit and cam signal circuit to PCM. Repair as necessary. If terminal contacts are okay, fault is not present. See DIAGNOSTIC AIDS.
scientia non olet · About LEMON Manuals