LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 1997 >> Seville STS >> Repair and Diagnosis >> Accessories & Equipment >> Memory Modules >> Memory System >> MEMORY SEAT MODULE (MSM) DIAGNOSTIC TROUBLE CODES (DTCs) >> MSM DTC B2115-B2120: Sensor Failed >> Diagnostic Procedures
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedures

  1. Disconnect appropriate position connector. See appropriate table under DIAGNOSTIC TROUBLE CODES (DTCS)  under SELF-DIAGNOSTICS. On recline sensor, rear height sensor and forward/back sensor, use DVOM to check voltage between terminals "A" and "D". On front height sensor, lumbar in/out sensor and lumbar up/down sensor, use DVOM to check voltage between terminals "B" and "D". If reading is about 5 volts, go to next step. If reading is not about 5 volts, go to step 4).
  2. Check for open or short in appropriate wire. See WIRING DIAGRAMS  . If circuit is okay, go to next step. If circuit is not okay, go to step 7).
  3. Replace appropriate position sensor. Go to step 8).
  4. Check for open or short in circuit No. 788 (Gray wire) between position sensor and splice S348. If circuit is okay, go to next step. If circuit is not okay, go to step 7).
  5. Check for open or short in circuit No. 782 (Black wire) between position sensor and splice S349. If circuit is okay, go to next step. If circuit is not okay, go to step 7).
  6. Check for poor connections at MSM 26-pin connector C1. If connections are okay, replace MSM. Go to step 8).
  7. Repair open or short in appropriate wire. See WIRING DIAGRAMS  . Go to next step.
  8. Clear DTCs. See CLEARING DIAGNOSTIC TROUBLE CODES (DTCS)  under SELF-DIAGNOSTICS. Reinstall and reconnect all components and connectors. Recheck system operation.
scientia non olet · About LEMON Manuals