Both Mirrors Do Not Manually Move Left & Right
NOTE:
After repair or component replacement is completed, perform MEMORY SYSTEM CHECK
under TESTING - SYSTEM CHECKS to verify system is operating properly.
- Perform MEMORY SYSTEM CHECK under SYSTEM CHECK. Go to next step.
- Using test light, backprobe between outside mirror switch connector terminals "E" (Orange wire) and "A" (Red/White wire). Move mirror switch left. Backprobe between outside mirror switch connector terminals "D" (Black wire) and "A" (Red/White wire). Move mirror switch right. If test light illuminates in both positions, go to next step. If test light does not illuminate in both positions, go to step 9).
- Using test light, backprobe between outside mirror switch connector terminals "E" (Orange wire) and "G" (White wire). Move mirror switch left. Backprobe between outside mirror switch connector terminals "D" (Black wire) and "G" (White wire). Move mirror switch right. If test light illuminates in both positions, go to next step. If test light does not illuminate in both positions, go to step 9).
- If both mirrors operate left and right during memory recall function, go to next step. If both mirrors do not operate during memory recall function, go to step 8).
- Disconnect outside mirror switch connector. Disconnect Memory Mirror module (MMM) Blue, 32-pin connector C1. See Figure . Using DVOM, check resistance between MMM harness connector C1, terminal E8 (Red/White wire) and outside mirror switch harness connector terminal "A" (Red/White wire). If resistance is less than 5 ohms, go to next step. If resistance is not less than 5 ohms, go to step 7).
- Repair open in circuit No. 881 (Red/White wire) between outside mirror switch and MMM connector C1. See WIRING DIAGRAMS .
- Repair open in circuit No. 1512 (White wire) between outside mirror switch and MMM connector C1. See WIRING DIAGRAMS .
- Replace Memory Mirror Module (MMM).
- Replace outside mirror switch. See MIRRORS - POWER article.