Diagnostic Procedures
- Perform POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK , then go to next step.
- Check for possible cause of Electromagnetic Interference (EMI), such as spark plug wires routed too close to IC module, high power transmitters operating within vicinity or the use of a battery charger. If possible source of EMI is found, remove source. If EMI interference is not noticed, go to next step.
- Clear DTC(s) and retest. If DTC P0371 resets, go to next step. If DTC P0371 does not reset, fault is not present.
- Check terminal contact of 24X spark reference circuit at IC module and PCM harness connector. Repair as necessary. If terminal contact is okay, go to next step.
- Replace IC module.