Circuit Description

The right heater temperature sensor (located behind right side of dash, in heater duct) is a thermistor that controls signal voltage to Instrument Panel Integration Module (IPM). The IPM applies voltage on circuit No. 520 (Black/white wire), between right heater temperature sensor and IPM. See WIRING DIAGRAMS  .

When sensor is cold, resistance is high and IPM will sense a high voltage signal at IPM harness connector terminal B9 (Black wire). When sensor warms up, resistance is reduced and signal voltage is pulled low through circuit No. 61 (Yellow wire), between IPC and sensor.

Signal voltage varies from 5 volts (open circuit) to zero volt (shorted circuit). DTC will set when ignition is on or when circuit is open or shorted.