Diagnostic Procedures
- Perform POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK , then go to next step.
- Check for possible sources of Electromagnetic Interference (EMI), such as spark wires routed too close to IC module, high power transmitter operating in the vicinity or a battery charger causing EMI. Correct problem, if present. If EMI is not present, go to next step.
- Clear DTC(s) and retest. If DTC P1370 resets, go to next step. If DTC does not reset, fault is not present.
- Check fuel control circuit terminal contact IC module connector C4 and PCM harness connector C2. Repair as necessary. If terminal contacts are okay, go to next step.
- Replace IC module.