Specifications Index
CATERA SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | Manual SPECIFICATIONS Automatic SPECIFICATIONS |
||
| Torque | Manual TORQUE SPECIFICATIONS Automatic TORQUE SPECIFICATIONS |
||
| Axle Nut/Hub Nut | NA | ||
| Battery | CAPACITIES | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Drum Brakes | NA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | DESCRIPTION | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | SERPENTINE BELT ROUTING & ALIGNMENT -- CARS | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 15 psi or specification stamped on cap. | ||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | With engine at normal operating temperature, oil pressure at idle should be approximately 21.7 psi. (1.525 kg/cm2 ). | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate Torque | |||
| Step 1 | 48 Ft. Lbs. (65 N.m) | ||
| Step 2 | Additional 30 Degrees | ||
| Step 3 | Additional 15 Degrees | ||
| Fuel System | |||
| Pressure Specification | 40-48 psi (2.8-3.4 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE TEST (EXCEPT SATURN) | ||
| Fuel Filter Location and R & I | REMOVAL PROCEDURE (CATERA) | ||
| Ignition | |||
| Firing Order & Cylinder Identification | See FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | 2000-3000 Ohms | ||
| Ignition Wires (Routing) | See appropriate figure under FIRING ORDER | ||
| Spark Plug | |||
| Type | Bosch FLR9LTE | ||
| Gap | .035-.043 In. (.9-1.1mm) | ||
| Torque | 19 Ft. Lbs. 25 N.m) | ||
| Starting | |||
| Starter | BENCH TESTING | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 80 Ft. Lbs. (109 N.m) | ||