LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2000 >> DeVille DTS >> Repair and Diagnosis >> Steering >> Steering Column >> Memory Systems >> Diagnostic Tests >> DTC B2772: Driver Memory Exit Switch Circuit Low >> Diagnostic Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedure

  1. If power seats diagnostic system check was performed, go to next step. If power seats diagnostic system check was not performed, go to POWER SEATS DIAGNOSTIC SYSTEM CHECK  under SELF-DIAGNOSTIC TESTS.
  2. Connect scan tool to Data Link Connector (DLC). See Figure . Turn ignition on. Using scan tool, select DRIVER DOOR SWITCH data list. Monitor MEMORY RECALL SWITCHES status. If MEMORY RECALL SWITCHES status is IDLE, go to next step. If MEMORY RECALL SWITCHES status is not IDLE, go to step  4 .
  3. Monitor MEMORY RECALL SWITCHES status. Press memory exit switch. If MEMORY RECALL SWITCHES status momentarily changes, check for intermittent or poor connections at switch. If MEMORY RECALL SWITCHES status does not change, go to next step.
  4. Turn ignition off. Disconnect memory switch connector. See Figure . Turn ignition on. Monitor MEMORY RECALL SWITCHES status. If MEMORY RECALL SWITCHES status is not IDLE, go to next step. If MEMORY RECALL SWITCHES status is IDLE, go to step  7 .
  5. Check for short to ground in Purple wire between memory switch connector terminal No. 4 and Driver Door Switch Assembly (DDSA) connector terminal No. 2. Check for short to ground in White wire between memory switch connector terminal No. 5 and DDSA connector terminal No. 3. See Figure . If circuit is okay, go to next step. If faulty circuit is found and repaired, go to step  10 .
  6. Check for poor connections at DDSA connector. If connections are okay, go to step  8 . If faulty connections are found and repaired, go to step  10 .
  7. Check for poor connections at memory switch connector. If connections are okay, go to step  9 . If faulty connections are found and repaired, go to step  10 .
  8. Replace DDSA. See DRIVER DOOR SWITCH ASSEMBLY  under REMOVAL & INSTALLATION. After repairs, go to step  10 .
  9. Replace memory switch. See MEMORY SWITCH  under REMOVAL & INSTALLATION. After repairs, go to next step.
  10. Use scan tool to clear DTCs. Recheck memory system operation. Recheck for DTC. If DTC resets, go to step  2 . If DTC does not reset, repair is complete.
scientia non olet · About LEMON Manuals