DTC B2477: Reverse Light Relay Shorted To Ground: Testing
- If lighting system diagnostic system check has been performed, go to next step. If lighting system has not been performed, go to LIGHTING SYSTEM DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM.
- Ensure transmission is in Park position. Remove REVERSE relay from rear compartment relay center No. 4. See Figure . Using DVOM, measure resistance between ground and REVERSE relay terminal C3 (Dark Green wire). See BACK-UP LIGHTS article. If resistance is 0-5 ohms, go to next step. If resistance is not 0-5 ohms, go to step 4 .
- Repair short to ground in Dark Green wire between rear compartment relay center No. 4 and PZM. After repairs, go to step 5 .
- Replace PZM. See PLATFORM ZONE MODULE (PZM) under REMOVAL & INSTALLATION. After repairs, go to next step.
- Use scan tool to clear DTCs. Recheck system operation. Recheck for DTCs. If DTC resets, go to step 2 . If DTC does not reset, repair is complete.