Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Align the inside air temperature sensor to the driver knee bolster trim panel, then push to secure the retaining tabs.
- Be sure to ALIGN the inside air temperature sensor with the inside air temperature sensor aspirator duct, while installing the driver knee bolster trim panel.
- Install the drivers knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster in Instrument Panel, Gages and Console.
- Install the I/P accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory in Instrument Panel, Gages and Console.
Fig 2: Drivers Knee Bolster Trim Panel, I/P Accessory Trim Plate & Inside Air Temperature Sensor Aspirator Duct
IMPORTANT:
The inside air temperature sensor must be aligned with and fit into the end of the inside air temperature sensor aspirator duct.