Removal & Installation (With Navigation)
- Radio is located below rear shelf on driver's side. Remove the front trim panel in rear compartment. See REAR COMPARTMENT TRIM PANEL
. Remove fasteners and cable clips from trunk pass-through release cable. Push rearward and upward on front of rear seat cushion. Disconnect heated seats electrical connectors (if equipped) and remove rear seat cushion.
- Remove center seat belt, shoulder belt buckle and seat back anchor bolts. Place center shoulder belt on rear shelf panel. Using a straight flat-bladed tool, insert between top of seat back and rear of shelf panel and push down on rear seat back retainers. See Fig 1
. Release 4 retainers and pull seat back away from vehicle.
- Remove pass through cable from seat back. Disconnect heated seat and rear lumbar electrical connector, if equipped. Position rear shoulder belts to clear rear seat back during removal. Remove the rear seat back from vehicle.
- Remove rear seat belt retractors. Remove 2 push fasteners from cross car beam and lift up on front and rear of rear shelf panel to release velcro. Lift shelf trim panel over child seat tethers and remove from vehicle.
- Remove fasteners retaining radio to radio/navigation processor bracket. See Fig 2
. Disconnect electrical connectors and antenna from radio. Remove radio and/or navigation processor from radio/navigation processor bracket. To install, reverse removal procedure.
Courtesy of GENERAL MOTORS CORP.
Courtesy of GENERAL MOTORS CORP.