Using Scan Tool
NOTE:
Procedure is written specifically for use with GM Tech I or Tech II scan tools. Generic scan tool can be used but may have limited functions.
To enter programming, perform these steps:
- Connect scan tool to Data Link Connector (DLC).
- Turn ignition switch to RUN position.
- Select current vehicle and model year.
- Select body.
- Select personalization.
- Select set options.
- Select Driver #1 Curb View or Driver #2 Curb View.
- Highlight Parallel Park Assist and press ENTER button to turn feature ON or OFF. An asterisk appears when feature is turned on.
- Exit from menu.