Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Refer to SIR Caution in Cautions and Notices.

CAUTION: Refer to SIR Inflator Module Handling and Storage Caution in Cautions and Notices.

Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .

Fig 1: Inflatable Restraint Module, Steering Wheel Module, Ground Wire, Horn Wiring Harness & Screws

Courtesy of GENERAL MOTORS CORP.

Remove the screws (4) retaining the inflatable restraint module (3) to the steering wheel.
Remove the inflatable restraint module (3) from the steering wheel.
Disconnect the connector position assurance (CPA) (1) from the electrical connector (2) on the module coil.
Disconnect the electrical connector (2) from the back of the steering wheel module (3).
Disconnect the horn wiring harness (6) from the steering column.
Disconnect the ground wire (5) from the steering column.
Remove the steering wheel module (3) from the vehicle.
Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .