Specifications Index
SEVILLE SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | 118 ft. lbs. (160 N.m) | ||
| Battery | BATTERY SPECIFICATIONS | ||
| Brakes | |||
| Bleeding Sequence | RR, LR, RF, LF also see MANUAL BLEEDING PROCEDURE | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | GENERATOR SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | See table under BELT ADJUSTMENT | ||
| Belt Routing | See appropriate illustration under SERPENTINE BELT ROUTING & ALIGNMENT | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 15 psi (or pressure marked on cap) | ||
| Thermostat R&I | NA | ||
| Water Pump R&I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | Lowest compression reading should not be less than 70 percent of highest compression reading. No cylinder compression reading should be less than 140 psi (9.8 kg/cm2 ). | ||
| Oil Pressure | Minimum oil pressure is 5 psi (.4 kg/cm2 ) at idle, and 35 psi (2.5 kg/cm2 ) at 2000 RPM. | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate Torque | |||
| Step 1 | 11 Ft. Lbs. (15 N.m) | ||
| Step 2 | Additional 50 Degrees | ||
| Fuel System | |||
| Pressure Specification (ignition ON and engine OFF) | 41-47 psi (2.9-3.3 kg/cm2) | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE TEST (EXCEPT AURORA & SATURN) | ||
| Ignition | |||
| Firing Order & Cylinder Identification | See FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Coil On Plug | ||
| Ignition Wires (Routing) | Coil On Plug | ||
| Spark Plug | |||
| Type | Denso | ||
| Gap | .050 in. (1.27 mm) | ||
| Torque | 15 ft. lbs. (20 N.m) | ||
| Starting | |||
| Starter | SYSTEM TESTS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 100 ft. lbs. (136 N.m) | ||