April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Description

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The number(s) below refer to the step number(s) on the diagnostic table.

2: This step identifies the transmitter with a low battery signal.
4: This step verifies that the battery replacement corrected the fault.

DTC B3109

Step	Action	Yes	No
1	Did you perform the Diagnostic System Check?	Go to Step 2	Go to Diagnostic System Check - Remote Keyless Entry
2	With a scan tool, clear the DTC. Press a button on each of the transmitters while monitoring the scan tool body control module (BCM) DTC list. Does the scan tool indicate that DTC B3109 reset when the button was pressed on any of the transmitters?	Go to Step 3	Go to Testing for Intermittent and Poor Connections in Wiring Systems
3	Replace the battery on the transmitter(s) that reset DTC B3109. Refer to Transmitter Battery Replacement. Did you complete the battery(s) replacement?	Go to Step 4	-
4	Use the scan tool in order to clear the DTCs. Operate the transmitter(s) that had the battery replaced. Does the DTC reset?	Go to Step 5	Go to Step 8
5	Replace the transmitter(s). Ensure that the replacement transmitter(s) is the correct model for the vehicle. All transmitters must be programmed at the same time. Refer to Transmitter Programming. Did you complete the replacement?	Go to Step 6	-
6	Use the scan tool in order to clear the DTCs. Operate the replaced transmitter(s) 3 consecutive times. Does the DTC reset?	Go to Step 8	Go to Step 7
7	IMPORTANT: When replacing the BCM, perform the transmitter programming procedure. Replace the BCM. Refer to in Body Control Systems.Did you complete the replacement?	Go to Step 8	-
8	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2